Our stock products are being manufactured in our plants continuously in order to provide you a shortest lead time as possible.
In the following table you may find typical lead times. They may vary depending on quantity and raw material availability. Some products are having an interchangeable parts.
You will receive an accurate delvery date on your order confirmation after you ordered.
|Optomechanics||Average 2 - 5 weeks*|
|Optics||Average 2 - 5 weeks*|
|Motorized Stages||Average 3 - 6 weeks*|
|System||Average 3 – 6 weeks*|
*This is an average typical lead time. For more details, please ask to: firstname.lastname@example.org
The stock availability for this product is limited at the moment. Please contact the sales team for more information at email@example.com.
Estimated average shipping time is 2 - 10 working days. For urgent shipping please contact the sales team at firstname.lastname@example.org. Extra charges may applies.
At this time pre-manufactured parts are already available for a quick assembly.
The typical lead times is estimated at 1 - 3 weeks after your order, depending on quantity.
You will receive an accurate delivery date on your order confirmation after you ordered.
For more details, please ask to : email@example.com
Designed to hold lenses with a range of diameters at a consistent center height.
Appropriate for applications where the lenses get changed out very often.
◦The three jaws of the holder will contact the edge of the lenses, and hold them with spring pressure.
◦Move the levers closer to each other to open the three jaws, and loosen their hold to close the jaws.
◦The position of the three jaws is locked by tightening the clamp.
Used for height and rotational coarse/fine adjustment of ...
Used for height and rotational coarse adjustment of a pos...
Stainless steel posts.
In case of using this rod, with...
Pedestal Bases can be mounted directly on a vibration iso...
▶Post length can be changed. If the length of post is specified at the time of purchase, this product will be delivered after replacing posts.
▶Replacement of holders with tapered posts will be charged. Contact our International Sales Division for more information.
▶Thin lenses may tilt and fall off from the holders when they are held with excessive spring pressure. Hold lenses with care.
▶Slight displacement will occur in the center of a lens every time a lens is released and gripped. For precise measurement, use two-axis lens holders with a centering mechanism (ALHN). (W4016)
|Primary material||Aluminum||Finish||Black Anodized|