Our stock products are being manufactured in our plants continuously in order to provide you a shortest lead time as possible.
In the following table you may find typical lead times. They may vary depending on quantity and raw material availability. Some products are having an interchangeable parts.
You will receive an accurate delvery date on your order confirmation after you ordered.
|Optomechanics||Average 2 - 5 weeks*|
|Optics||Average 2 - 5 weeks*|
|Motorized Stages||Average 3 - 6 weeks*|
|System||Average 3 – 6 weeks*|
*This is an average typical lead time. For more details, please ask to: email@example.com
The stock availability for this product is limited at the moment. Please contact the sales team for more information at firstname.lastname@example.org.
Estimated average shipping time is 2 - 10 working days. For urgent shipping please contact the sales team at email@example.com. Extra charges may applies.
At this time pre-manufactured parts are already available for a quick assembly.
The typical lead times is estimated at 1 - 3 weeks after your order, depending on quantity.
You will receive an accurate delivery date on your order confirmation after you ordered.
For more details, please ask to : firstname.lastname@example.org
The transmission loss is minimal, and a high extinction ratio below 5×10-5 is obtained. The Calcite type that can be used in the visible to the infrared region, and α-BBO crystal type usable in the ultraviolet region are available. The polarizer provides a very short prism length.
◦The two prisms are mounted with a small gap (air-gap) to eliminate the adhesive and reduce laser damage.
◦A single-layer anti-reflection coating has been applied on the surface of the polarizing prism to provide high transmittance.
▶Glan laser prism for high-power laser (GLPB / GLP) and Wollaston prism (WPPB / WPPC) are also available.
▶If you need uncoated Glan Thompson prism or anti-reflection coating with specific reflectance, please contact our Sales Division with your request.
▶A change in the incident angle may also changes the extinction ratio of the linearly polarized transmitted light.
▶Light not transmitted through the Gran Taylor prism is absorbed and scattered in all side faces of the prism. In the high-precision measurement system, it is necessary to use pinhole to block light scattered in the side face of the prism.
▶Because of natural calcite crystals, there are individual differences, and variations in quality.
|Material||α-BBO , Calcite|
|Angular deviation of beam||＜3′|
|Transmitted wavefront distortion||λ/4|
|Coating||Both surfaces ; MgF2 single-layer antireflection coating|
|Laser Damage Threshold||1J/cm2 (Laser pulse width ; 10ns )|
|Surface Quality (Scratch-Dig)||20-10|
|Material propreties||Aluminum ( Finishing ; Black Anodized)|